IMPORTANT: Do Not asssemble handle tube to same

side of crossover tube as shaft support plate.

9.Place the long handle tube onto the crossover tube on the side opposite from the shaft support plate. Fasten with the 1/4" hex bolt, flat washer and hex lock nut removed in the previous step. See figures 4 and 5. Do not tighten at this time.

10.Assemble two handle braces to the inside of the hopper frame, one on each side, using two 1/4" x 1-1/2" hex bolts and two 1/4" lock nuts. See figure 5. Do not tighten at this time.

11.Assemble the other end of the two handle braces to the long handle tube using a 1/4" x 1-1/2" hex bolt and 1/4" lock nut. Do not tighten at this time.See figure 5.

12.Tighten all hex lock nuts and bolts in same sequence as assembled in steps 9 through 11. See figure 5.

HANDLE TUBE (LONG)

HEX BOLT 1/4" x 1-1/2"

HITCH

BRACE HEX BOLT 1/4" x 1-1/2"

1/4" HEX BOLT

1/4"

LOCK

NUT

CROSSOVER

TUBE

FLAT WASHER

SHAFT

1/4" HEX SUPPORT

LOCKNUT PLATE

FIGURE 5

13.Assemble the leg stand tube to the handle tube (long) using two 1/4" x 1-1/2" hex bolts. Secure tightly with two 1/4" hex lock nuts. See figure 6.

14.Place a vinyl cap over the end of the leg stand tube. See figure 6.

HANDLE TUBE (LONG)

1/4" x 1-1/2"

HEX BOLTS

1/4"

LOCK

NUT

VINYL CAP

LEG STAND TUBE

FIGURE 6

15.Assemble the flow control link (end with small hole) to the flow control arm using a 1/4" x 3/4" hex bolt, a nylon washer and a 1/4" hex lock nut as shown in figure 7. Tighten carefully. The flow control link should not be loose but should pivot with no more than slight resistance.

FLOW CONTROL

 

LINK

FLOW

 

CONTROL

 

ARM

1/4" x 3/4"

 

HEX BOLT

 

 

1/4" HEX

 

LOCK NUT

SMALLEST

HOLE

NYLON

WASHER

FIGURE 7

5