5.Assemble the two hitch braces to the hitch tube using a

1/4" x 1-1/2" hex bolt and a 1/4" nylock nut. See figure

3. Do not tighten at this time.

6.Tighten all loose hex nuts and bolts attached to hitch tube and hitch braces. Do not collapse tubes when tightening.

8.Place the drive wheel onto the end of the axle that has an indent. The long end of the hub goes to the inside.

See figure 5.

9.Place a hub cap onto the end of the axle. Using a small hammer, lightly tap the hub cap until it is snug against the wheel. See figure 5.

HITCH

TUBE

1/4" x 1-1/2"

1/4" NYLOCK

 

HEX BOLT

NUT

 

HITCH BRACE

HITCH BRACE

FIGURE 3

7.Assemble a spacer and then a 1/2" flat washer onto each end of the axle. See figure 4.

AXLE

SPACER

1/2" DIA.

FLAT WASHER

FIGURE 4

INDENT

HUB CAP

FIGURE 5

10.Place the wheel (long end of hub first) onto the end of the axle that has no indents. See figure 6.

11.Place a 1/2" flat washer onto the axle and then lightly tap a hub cap onto the axle until it is snug against the washer and wheel hub. See figure 6.

END WITH NO

INDENT

1/2" FLAT WASHER

HUB CAP

FIGURE 6

3