ASSEMBLY (ALL MODELS)
1.Assemble seven spring tines to the top of the frame tube. Use a 5/16" x
NOTE: On sweepers smaller than 42", use only five spring tines.
2.Assemble a vinyl cap onto each end of the frame tube. See figure 1.
5/16" x
HEX BOLT
3/8" WASHER
5/16" NYLOCK NUT
FIGURE 1
3.Assemble a 1/2" washer, the wheel, another 1/2" washer and a 1/2" plain jam nut onto the 1/2" x
4.Insert the bolt through the welded bracket and assemble a 1/2" nylock jam nut onto the bolt. Adjust nuts so that there is no end play in the wheel and then tighten securely against the welded bracket. Make sure the wheel still turns freely. See figure 2.
Use this hole for 42" & 46" sweepers
Use this hole for smaller sweepers and SMARTSweepers
1/2" NYLOCK
JAM NUT
1/2" JAM NUT
1/2" WASHER
1/2" x
FIGURE 2
ASSEMBLY (NON-SMARTSWEEP MODELS)
1.Assemble a conduit clamp onto each end of the sweeper height adjustment tube so that the straight part of the clamp is on top of the tube. See figure 3.
2.Remove the hitch brackets and the bolts, if present, from the ends of the sweeper's hitch tubes. Slide the transport hook onto the L.H. hitch tube as shown in figure 3.
3.Reassemble the hitch brackets and bolts to the hitch tubes. Refer to your sweeper owner's manual.
TRANSPORT
HOOK
CONDUIT
CLAMP
FIGURE 3
4.Connect the sweeper to the tractor. Set the sweeper height adjustment handle to about the middle of it's adjustment range.
5.Place the dethatcher in front of the sweeper housing, underneath the hitch tubes.
6.Connect the dethatcher to the conduit clamp using two 5/16" x
HEIGHT ADJUSTMENT MIDDLE SETTING
5/16" x
CLEVIS PIN
5/16" WASHER
3/32" HAIR COTTER PIN
FIGURE 4
4