ASSEMBLY
INNER NUT
OUTER NUT
CLUTCH CABLE ADJUSTMENT
•Remove four screws from Rear Drive Cover. Lay aside cover and screws.
•Place Clutch Lever in “DISENGAGED" position
•The Cable should be under slight tension but should not pull the Clutch Lever more than 1/8" away from the Switch Body.
NOTE: If the Plunger extends more than 1/8" out from the switch body, the cable tension is too tight and the Engine will not start.
SWITCH
BODY
1/8"
PLUNGER
CLUTCH LEVER
FOUR SCREWS
REAR DRIVE
COVER
FIG. 2
TO INCREASE CABLE TENSION
•Place Blade Clutch Lever in the “DISENGAGED" position.
•Loosen the inner nut on the Clutch Cable.
•Tighten the outer nut on the Clutch Cable.
TO DECREASE CABLE TENSION
•Place Blade Clutch Lever in the “DISENGAGED" position.
•Loosen the outer nut on the Clutch Cable.
•Tighten the inner nut on the Clutch Cable.
•Repeat the above procedure until you have the correct tension.
| IDLER |
ENGINE | PULLEY |
| |
PULLEY |
|
BLADE |
|
PULLEY |
|
CLUTCH LEVER
10