
ASSEMBLY
INSTALL BATTERY
Your Trail Mower requires a 12 volt battery to operate. The battery is NOT included with the unit. It must be purchased separately.
•Remove four screws and the Battery Cover from the Mower and set them aside.
•Install two Plastic Nuts into the square holes in the Mower Deck under the Battery Cover.
•Place the Battery on the Mower Deck between the two Plastic Nuts.
•Place the Battery Hold Down on top of the Battery.
•Secure the Battery to the Mower Deck with two 1/4 x
•Open the terminal access doors on the Battery Hold
Down.
•Connect the Red Wire to the positive (+) battery terminal using a 1/4 x 3/4 hex bolt and 1/4 SEMS nut. Tighten securely.
•Connect the Black Wire to the negative
Tighten securely.
•Close the terminal access doors.
•Replace Battery Cover and secure it with the four screws.
INSTALL TOWBAR TUBE TO REAR
QUADRANT
•Place Towbar Tube into Rear Quadrant, align holes and insert 3/8 x
•Secure tightly with 3/8 Hex Lock Nut and then loosen 1/4 turn to allow Tube to pivot freely inside Rear
Quadrant.
•Insert 3/8 X
Rear Quadrant and into hole in Towbar Tube.
•Secure Tightly with 3/8 Flat Washer and 3/8 Hex Lock Nut, then loosen 1/4 turn to allow Tube to pivot freely inside Rear Quadrant.
NOTE: Towbar Tube must pivot freely inside Rear Quadrant when Latch is pulled from notch.
INSTALL CLUTCH CABLE TO TOWBAR TUBE
•Place Clutch Cable forward along Towbar Tube.
•Spread ends of two Cable Clips and place around
Clutch Cable.
•Place Clutch Cable on top of Towbar Tube and align
Cable Clips with bolt holes in Towbar Tube.
•Secure with two #10 Screws.
INSTALL CLUTCH CABLE TO CLUTCH LEVER
•Remove outer 5/16 Nut from end of Clutch Cable Housing. (See Fig. 1)
•Turn inner 5/16 Nut to bottom of thread.
•Insert Cable and outer 5/16 Nut through slotted hole in Cable Guide of Hitch Assembly. The outer 5/16 Nut musts be cocked sideways to insert through slotted hole of Cable Guide.
•Reinstall outer 5/16 Nut to the cable housing to secure
Cable Harness to Cable Guide.
•Install Mounting Anchor of Clutch Cable to Clutch Lever using Clevis Pin and Hair Cotter Pin.
8