25.Assemble a short tarp strap to rear door using one
1/4" x
1/4" nylock nut. Assemble an "S" hook through loose end of strap. See figure 15. Repeat on other side of door.
26.Assemble door to rear of cart by resting bottom of door on door supports and pushing top of door in against cross brace. Secure top of door using door latches on each side. See figure 15.
27.Hook both the tarp straps onto the 1/4" x 1" hex bolts in the sides of the cart. See figure 15.
DOOR LATCH
| 1/4" x |
| 1/4" FLAT WASHER |
| TARP STRAP (SHORT) |
1/4" FLAT | "S" HOOK |
| |
WASHER |
|
| DOOR |
1/4" NYLOCK NUT | SUPPORTS |
| 1/4" x 1" |
| HEX BOLT |
FIGURE 15
28.Attach the engine/impeller housing assembly to the upper holes in the angles welded to the tongue. Use four 5/16" x 3/4" hex bolts and 5/16" nylock nuts.
Tighten. See figure 16.
5/16"
NYLOCK NUT
5/16" x 3/4"
HEX BOLT
WELDED | FRONT |
ANGLES | TONGUE |
FIGURE 16
29.Assemble the elbow to the impeller housing using four 5/16" x 3/4" self tapping hex bolts and four nylon washers. Push while turning to help start the bolts into the unthreaded holes. Tighten. See figure 17.
30.To center the elbow with the opening in the hard top:
a.Push the vinyl boot back inside the opening.
b.Loosen by approximately 1/4 turn each, the four bolts that you assembled in figure 16.
c.Push against the elbow to center it with the sides
of the opening.
d. Retighten the four bolts that you loosened.
31. Pull the vinyl boot onto the end of the elbow.
Center elbow between sides of opening
NYLON
WASHER
5/16" x 3/4"
HEX BOLT
(Thread Forming) 
Loosen (4) bolts 1/4 turn each
FIGURE 17
11