![](/images/new-backgrounds/1310298/3102985x1.webp)
PROGRAMMING
DB-1SD ID Registration Procedure:
Install and wire all units, plug in the power supplies, then turn on power switches.
IMPORTANT: Make sure the power switches on all units are ON and the system is in standby mode before beginning registration process.
1.Before the ID registration is set, the red Talk LED will flash on the
2.Push and release the TALK button on the first
3.The LED will stop flashing to indicate that the ID registration is complete for that unit.
4.Go to each subsequent
5.You’re done!
DB-1SD ID Reset Procedure:
If you get an error tone (3 beeps) when you press the Call button, TALK button, Key button, or Option button, then there is a duplicate ID and you must reset all of the station ID’s and start over.
Beep! Beep! Beep!
To reset an ID, push and hold the OFF button while pushing the TALK, CALL, and DOOR RELEASE buttons simultaneously.
The LED on the TALK button will begin flashing, indicating that the ID in that unit is no longer set.
Repeat this process for each subsequent
Pg. 3