WIRING DIAGRAM:
NO
COM
NC
To Strike
& Power
TESTING & OPERATION:
Connect the reader to the host according to the wiring table below and the host installation guide.
Wiegand Wire | Color |
|
|
+ DC | Red |
Ground | Black |
Data0 | Green |
Data1 | White |
Shield Ground | Drain |
Green LED | Orange |
Red LED | Brown |
Beeper | Yellow |
Hold | Blue |
Card Present | Violet |
|
|
•When power is applied to the card reader, the LED will flash green three (3) times while the beeper beeps simultaneously. The LED will then turn red. This indicates that the microcontroller is operating properly.
•Present an ID card to the reader (hold card directly in front of reader). The LED will momentarily turn green while the beeper beeps once, indicating that the card was read successfully.
SPECIFICATIONS:
CARD READER: |
| DOOR UNIT: |
|
Reader type: | 6005B ProxPoint Plus | Terminations: | RJ45 jack for audio |
Power Source: | 5 ~ 16V DC |
| Screw terminals for door release |
Max Voltage: | 18V DC | Operating Temp: | 14° ~ 140°F / |
Current: | 30mA (Avg); 75mA (peak) | Wiring Distance: | 980’ with Cat5e/6 cable |
Terminations: | Dimensions: | ||
Wiring Distance: | 500’ | ||
Operating Temp: | 14° ~ 140°F / |
| (top), |
Operating Humidity: |
|
| |
|
|
|
Aiphone Corporation
1700 130th AVE NE
Bellevue, WA 98005
(425)
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference that may cause undesired operation.
•For proper regulatory compliance, the drain wire should be disconnected at the power supply end of the cable.
•Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
•The Reader is intended to be powered from a limited power source output of a previously certifed power supply
TOLL FREE TECHNICAL SUPPORT:
(800)
Pg. 2
