WIRING DIAGRAM:
Master
A1
A2
Output to Host
Access Control System
TESTING AND OPERATION:
1A1
1A2
2A1
2A2
S
S
B1
B2
+ |
- |
+ |
- |
When power is applied to the card reader, the LED will flash green three (3) times while the beeper beeps simultaneously. The LED will then turn red. This indicates that the microcontroller is operating properly.
Present an ID card to the reader. (Hold card directly in front of reader.) The LED will momentarily turn green while the beeper beeps once, indicating that the card was read successfully.
SPECIFICATIONS:
CARD READER: |
| CAMERA: |
|
Power Source: | 5 ~ 16V DC | Camera unit: | CCD Camera |
Absolute Max. Voltage: | 18V DC | Scanning line: | 525 lines |
Current Requirements: | 30mA (Avg); 75mA (peak) | Min. illumination: | 5 Lux at 1' or less |
Terminations: | Terminations: | Screw terminals | |
Wiring Distance: | 500' | Wiring Distance: | 330' w/871802 wire |
Operating Temperature: |
| 980' | |
Operating Humidity: | Dimensions(camera): | ||
| With | ||
|
|
|
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference that may cause undesired operation. For proper regulatory compliance, the drain wire should be disconnected at the power supply end of the cable.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The Reader is intended to be powered from a limited power source output of a previously certified power supply.
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005 | TOLL FREE TECHNICAL SUPPORT: (800) | Pg. 2 |
(425) | TOLL FREE FAX LINE: (800) | |
FAX (425) | 0706JDJS |