Aiphone PAA-100F installation instructions Supplemental Regulator Unit, Instructions, Existing

PAA-100F

Supplemental Regulator Unit

For RCX-88 and RCX-128 Systems that include the ALL CALL Feature

- INSTRUCTIONS -

The RCX-88 and RCX-128 Systems have the All Call feature as an option. This option requires more power than the standard CEU provides. The PAA-100F Supplemental Regulator Unit provides the necessary power to operate the system and the All Call feature. This unit replaces the HR-10-12 power source that comes standard in the RCX-88 and RCX-128.

INSTALLATION:

1.Locate existing HR-10-12 at the top of the RCX-88 or RCX-128.

2.Mark wires with terminal locations before disconnecting, then disconnect and remove the unit.

3.Remove the aluminum plate from the bottom of the HR-10-12 and reattach it to the bottom of the PAA-100F. Install the new regulator unit in place of the original one.

4.Reconnect the wires to the PAA-100F in the same way that they were connected previously.

Note some of the terminal definitions are labeled slightly differently, but they have the same function.

TOP OF RCX-88 or RCX-128	Existing HR-10-12 Wiring:
EXISTING:		+S
	Wht
		+
	Blk	-	Blk
		-S
		TOG
	Grn	CNT	Grn
		FG
	Wht		Wht
		AC
	Wht		Wht
		AC

NEW:	Replace with PAA-100F and
	connect as follows:

Wht	+S
	+V
Blk	-V	Blk
	-S
Grn	GND	Grn
Wht	ACL	Wht
Wht		Wht
	ACV

ADD JUMPER:

Inside CEU on mother board

(rear vertical plane)

	Connector
	attached here
Install	GND	No Connector
	Vadd
		attached
jumper
	12V

Multi-pin male connector on right side -- solder middle two pins together with jumper wire.

Aiphone Communication Systems	TOLL FREE TECHNICAL SUPPORT:
1700 130th Ave. N.E.	(800) 692-0200
Bellevue, WA 98005	TOLL FREE FAX LINE:
(425) 455-0510
FAX: (425) 455-0071	(800) 832-3765

NOTE:

Only wiring concerning the supplemental regulator unit is shown here. For complete installation and wiring information, please see the complete RCX Installation instructions.

paa-100f.vsd

121997jd