No sound or only a very low-level

sound is heard from the surround

speakers.

,Make sure a proper sound field function is selected (page 15).

,Adjust the speaker volume (page 14).

The remote does not function.

,Remove any obstacles between the remote and the system.

,Use the remote near the system.

,Point the remote at the remote sensor on the system.

,Replace all the batteries in the remote with new ones if they are weak.

The system does not operate

properly.

,Static electricity, etc., may affect the system’s operation. Disconnect the AC power cord (mains lead) once, then connect it again.

USB connection

The computer does not recognize

this system.

,Make sure the system is connected to the computer with the supplied USB cable.

,It is recommended to connect the USB cable directly to the USB port of the computer.

There is no sound.

,“Mute” is selected in the Volume Control window. Open the Volume Control window and cancel “mute.”

,The volume level is low, open the Volume Control window and adjust the volume.

,Open the Sound and Multimedia Properties window and click the Audio tab. Select this system as the preferred device.

There is no sound from 5.1ch sound

,Select any sound field other than “H-T” or “2CH” when using “WinDVD.”

,Check the output setting of “WinDVD” is set correctly (page 20).

,The number of channel your computer outputs using “WinDVD” vary depends on the disc.

There is no sound from Audio CD.

,If the CD-ROM drive is not compliant with digital audio output, the sound from the CD- ROM drive will not be output via the USB connection. In this case, connect the audio output of the CD-ROM drive (e.g., the headphones output) to the ANALOG IN jacks and adjust the volume appropriately.

,If you use Windows 98 SE, confirm the

setting of the audio device.

 

1 Open the Control Panel window.

 

Additional

2 Open the Multimedia window and select

 

the USB audio device as the preferred

 

device for sound playback.

 

3 Select the CD Music tab. If the computer

 

has more than one CD-ROM drive, play

Information

back a music CD. Select the drive and

 

check “Enable digital CD audio for this

 

CD-ROM device.”

 

The sound is interrupted.

 

,The sound may be interrupted if other USB devices are connected or disconnected.

,If your computer does not meet the system requirements, it may not perform well. Besides, even if your computer meets the system requirements, the sound may be interrupted if the computer is under load. In this case, shut down other applications.

Returning to the default settings.

While the power is off (the ?/1 (POWER) indicator lights up red), press ?/1 (POWER) for 5 seconds until “INI” appears in the display.

23GB