Aiwa XR-EM220, XR-EM330, XR-EM550 Messages, OVER, Tape, 25GB, Tuner, Timer, CD/MP3, NO TAB, NO DISC, NO STEP, NO TAPE, TIME NG, COMPLETE, STEP FULL, PUSH STOP, SET CLOCK, SET TIMER, PUSH SELECT

•Refer to the operating instructions supplied with the connected component and start playing.

•Press FUNCTION repeatedly until “MD” appears (page 22).

The sound is distorted.

•Set the volume of the connected component lower.

If the system still does not operate properly after performing the above measures, reset the system as follows:

Use buttons on the unit for the operation.

1Disconnect the power cord.

2Reconnect the power cord.

3Press ?/1 to turn on the system.

4Press x, ?/1 and turn volume to the left at the same time.

The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock, and timer.

Messages

One of the following messages may appear or flash in the display during operation.

CD/MP3NO DISC

There is no disc in the player.

NO STEP

All of the programed tracks have been erased.

OVER

You have reached the end of the disc while pressing and holding M during playback or pause.

STEP FULL

You tried to program 26 or more tracks (steps).

PUSH STOP

You pressed PLAY MODE during playback.

Tuner

COMPLETE

The preset operation ended normally.

TapeNO TAB

You cannot record the tape because the tab has been removed from the cassette.

NO TAPE

There is no tape in the tape deck.

TimerSET CLOCK

You tried to select the timer with the clock not set.

PUSH SELECT

You tried to set the clock or timer during timer operation.

SET TIMER

You tried to select the timer when Play Timer or Rec Timer are not set.

TIME NG

Play Timer or Rec Timer start and end times are set to the same time.

continued

Troubleshooting

25GB