DOUBLE CHAIN
CHAIN GUARDS
ST15 / ST10
1.Only Double Chain Guards are available.
2.9 Link sections of Chains are used and are hung by the 5 th link to form the double Chain Guard. (See illustration below)
3.The Cables are laced through the Bottom Link of the Chain and then a Cable Clamp is placed at each end of the Cable. (See illustration below).
4.Front Center Section is in 3 pieces, 1 center (19 Chains) and 2 outer (16 Chains ea.)
5.The Front Wings are 2 pieces (29 Chains ea.) on each wing, same LH or RH. There are two Chain Sections that bolt to a lug on the outer side of each wing.
6.The Rear Center is in 2 pieces (24 Chains ea.)which are both the same LH or RH Center.
7.The Rear Wings use 3 pieces, The center and inner Wing piece are the same (19 Chains ea.), the outer for the wings is different (18
Chains)
8.The Chains are held in with a steel rod that is welded to the chain guard bracket. to change or install chain sections these rods should be replaced and rewelded.
9 Link Chain Section is hung by inserting the 5 th. Link
Chain Guard | Mower | |
Deck | ||
Bracket | ||
| ||
Retaining Bolt |
|
Retaining Rod
(Welded to
9 Link ChainBracket)
Section
ST15 (Archive Book) 01/04 | 64 |
© 2004 Alamo Group Inc.
