Specifications
Power Requirements | Voltage: |
| Current: |
|
|
Dimensions | D: 201mm W: 210mm H: 120.3mm |
(depth x width x height) | (7.9” x 8.3” x 4.7”) |
Weight | 1.02kg (2.2 Lbs.) |
|
|
Note: Specifications subject to change without notice.
Troubleshooting
If your HDD Copy Dock Duplicator is not performing as expected, refer to the symptoms below, and follow the suggested corrective action.
Symptoms | Corrective Actions |
|
|
LCD Display | If the LCD display does not display any message and |
| the backlight is not lit after powering on the HDD Copy |
| Dock Duplicator, check that the power cable is properly |
| connected and that the ON/OFF switch is turned on. |
Error Messages | While the system is performing an operation and the |
| operation is manually terminated, an error message will |
| be shown in the LCD display. This may lead to an failed |
| operation and could cause the HDD Copy Dock Duplicator |
| to stop responding. If this happens, power the unit off, wait |
| about ten (10) seconds, and then reapply power. |
Hard Disk | If the HDD Copy Dock Duplicator does not detect one |
| of the hard disk drives, verify that the drive is properly |
| connected. Power off all HDD’s. Wait 10 seconds then |
| power on. |
Keypad Buttons | If pressing the keys on the front panel produces no |
| response from the system, the HDD Copy Dock Duplicator |
| may still be busy with the previous operation. If the system |
| is idle, power the unit off, wait about ten (10) seconds, and |
| then reapply power. |
Startup/Shutdown | Do not power off the system while it is performing an |
| operation. After a normal shutdown, wait about ten (10) |
| seconds before reapplying power. |
18www.aleratec.com