Using the RoboJet Disc AutoPrinter
Getting to know the RoboJet Disc Autoloader application
A
B
C
G
H
D
I
E
F
J
K
A.Printer Status Panel – Shows the status of your disc autoloader equipped printer, if one is detected.
B.Dry Disc Timeout – Sets a delay before dropping a completed disc into the bin for discs that need a little more time to dry.
C.Refresh Devices button – Rescans your hardware to identify your disc autoloader equipped printer.
D.Flip Down button – Sends a command to the disc autoloader to release a disc that is in the disc tray to the disc bin.
E.Tray In button – Sends a command to the disc autoloader to load the disc tray into the printer.
F.Device Status – Shows the status of disc autoloader.
G.Unload Disc Vibration Number – “Disc vibrations” are used to insure that discs are dispensed properly by vibrating the tray hinge. This sets the number of additional vibrations (on top of the preset of 2 vibrations).
H.Load Disc button – Sends a command to the disc autoloader to load a disc into the disc tray.
I.Flip Up button – Sends a command to the disc autoloader to reset the disc release hinge on the disc tray to its normal position.
J.Tray Out button – Sends a command to the disc autoloader to unload the disc tray from the printer.
K.Start Autoloader button – Prepares the disc autoloader for printing discs. The autoloader application must be running before any disc print jobs can be started.
Note: Closing the RoboJet Disc Autoloader application will minimize it to your System Tray.
16www.aleratec.com