Alliance Laundry Systems DRY2033N, DRY2034N, DRY2035N, DRY2036N, DRY2037N, DRY2038N, DRY2039N, DRY2040N, DRY2041N, DRY2042N, DRY2043N, DRY2044N, DRY2045N, DRY2046N, DRY2047N, DRY2048N, TLW1991, TLW1991N, TLW2010N, TLW2011N, TLW2012N, TLW2013N, TLW2014N, TLW2015N, TLW2016N, TLW2017N, TLW2018, TLW2019N, TLW2020N, TLW2021N, TLW2022N, TLW2023N, TLW2024N, TLW2025N, TLW2027N, FLW2169N, FLW2170N, FLW2171N, FLW2172N, FLW2173N, FLW2174N, FLW2175N, FLW2182N, TLW1990N, TLW1994N 28

Filter Screens

Check the filter screens in the fill hoses for debris or damage annually. Clean or replace them if necessary.

If the washer is filling with water slower than normal, check the filter screens. Clean or replace them if necessary.

Order filter screen Part No. F270300 from the nearest authorized parts distributor.

Vacations and Extended Non-Use

•To avoid possible property damage due to flooding, turn off the water supply to the washer whenever there will be an extended period of non-use.

•Leave the loading door open during extended periods of non-use to allow the wash drum to dry out and avoid a musty smell.

Reinstallation of Shipping Materials

To prevent damage while moving the unit, the shipping materials MUST be reinstalled.

•Disconnect washer from electrical supply.

•While supporting the front access panel, remove two screws from the bottom edge of the panel.

•Gently lower the panel to remove it from the washer.

•Place the shock sleeves on all four shock absorbers. Refer to the illustration below.

Shock

Sleeves

Motor

Mount

Hooked End of

Shipping Brace

FLW2182N

Bolts and Lockwashers

FLW2182N

Refer to the INSTALLATION INSTRUCTIONS for proper procedures whenever the washer is moved.

Cleaning Foreign Object Trap

The washer’s pump has a trap that may collect foreign objects. The trap may need to be cleaned if water is draining slower than usual. To clean:

•Disconnect washer from electrical supply.

•While supporting the front access panel, remove two screws from the bottom edge of the panel.

•Gently lower the panel to remove it from the washer.

NOTE: The pump may have some water in it. Use a rag or a container to catch water. If the wash drum is full of water, use a wet/dry shop vacuum to catch the water.

•Insert hooked end of shipping brace into the open slot of the motor mount.

•Attach the brace with the five bolts and washers. Refer to the illustration below.

•Reinstall front access panel.

•With rag or vacuum ready, unscrew the cap on the left side of the pump and remove trap.

•Clean the debris from the trap.

•Reinstall the trap and access panel.

•Reconnect washer to electrical supply.

-28-

802753