Maintenance

Daily (Continued)

End of Day

1.Clean the AC drive box filter:

a.Snap off the external plastic cover which contains the filter.

b.Remove the foam filter from the cover.

c.Wash the filter with warm water and allow to air dry. Filter can be vacuumed clean.

2.Clean the door gasket of residual detergent and all foreign matter.

3.Clean automatic supply dispenser and lid inside and out with mild detergent. Rinse with clean water.

4.Clean the washer’s top, front, and side panels with mild detergent. Rinse with clean water.

5.Leave loading door open at the end of each day to allow moisture

to evaporate.

Note: Unload the machine promptly after each completed cycle to prevent moisture buildup. Leave loading door open at the end of each completed cycle to allow moisture to evaporate.

Weekly

1.Check the machine for leaks.

a.Start an unloaded cycle to fill the machine.

b.Verify that door and door gasket do not leak.

c.Verify that the drain valve is operating. If water does not leak out during the prewash segment, drain valve is closed and functioning properly.

Monthly

Note: Disconnect power to the machine

at its source before performing the monthly maintenance procedures.

1.Clean the AC drive fins:

a.Remove the AC drive box cover.

b.Blow the fins clean using compressed air at a pressure of 60 – 90 psi or by using canned compressed air. Use care to avoid damaging cooling fan or other components.

Note: No amount of visible foreign matter should be allowed to accumulate on the fins or the finger guard.

2.Use the following procedures to determine if the V-belt requires replacement or adjustment. Call a qualified service technician in either case.

a.Check V-belt for uneven wear and frayed edges.

b.After disconnecting power to the machine and removing all panels necessary for access to the drive belt, use the following method to verify that the V-belt is properly tensioned.

34

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232060