Introduction
Nameplate Location
The nameplate is located at the rear of the machine and near supply valves. Always provide the machine’s serial number and model number when ordering parts or when seeking technical assistance. Refer to Figure 1.
2
1
P
U
S
H
PHM598N
PHM598N
1Near Supply Valves
2Top of Module
Figure 1
Replacement Parts
If literature or replacement parts are required, contact the source from whom the machine was purchased or contact Alliance Laundry Systems at (920)
Customer Service
For technical assistance, call: (920)
Summary of Control Outputs and Inputs
Outputs
General outputs provide signals to operate the following components.
1.Hot Fill Valve
2.Cold Fill Valve
3.Drain Valve (normally open)
4.Door Unlock Solenoid Coil
5.Supply 1 (detergent)
6.Supply 2 (bleach)
7.Supply 3 (sour/softener)
8.Supply 4
9.Supply 5 or Optional 3rd (auxiliary) Fill Inlet (governed by the configuration settings)
10.Optional Heat
For standard models, the components for outputs shown as “optional” will not be populated on the output printed circuit board.
AC outputs are solid state outputs that operate either 120 Volt AC or 220 Volt AC (nominal voltage) components, depending on the control voltage configuration. Outputs are fused appropriately.
Inputs
1.Low Water Level
2.Medium Water Level
3.High Water Level
4.Door
5.Temperature Signal
Control Voltage
The control power supply is configured to operate on 220 Volt AC nominal RMS input voltage 50/60 Hertz.
6 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F232227 |