Allstar Products Group 8833 OCS, 8833C OCS Commercial Receiver, Transmitter Coding Instructions

COMMERCIAL RECEIVER &

TRANSMITTER CODING INSTRUCTIONS

The information below indicates how to set the coding switches in the various transmitters and receivers.

IF YOU ARE USING A 8833 OCS-ECONOMY OR 831 STANDARD TRANSMITTER:

Exactly match all 8 code switches in the transmitter and receiver. The code switches may be set in any random pattern of +, - and 0.

IF YOU ARE USING A 8833C OCS-ECONOMY OR 733 STANDARD TRANSMITTER:

This transmitter is used to control up to 3 different doors. This is accomplished by setting the selector switch on the transmitter to either A, B & C and setting the #6 coding switch in the 831 receiver .

TRANSMITTER	RECEIVER
A-B-C Selector	Coding Switch
Switch Position	#6
A	+
B	0
C	-

Start coding by exactly matching all 8 code switches in the transmitter and the receivers. The code switches may be set in any random pattern of +, 0 and - positions. Next, in receiver A, set code switch #6 to the + position; In receiver B set code switch # 6 to the 0 position; In receiver C set code switch # 6 to the - position. The table to the right shows the switch positions.

IF YOU ARE USING A 639 STANDARD TRANSMITTER:

This transmitter is used to control up to 9 different doors. This is accomplished by setting the selector switch on the transmitter to either 1, 2, 3, 4, 5, 6, 7, 8 or 9 and setting the #7 and #8 coding switches in the 831 receiver.

Start coding by exactly matching all 8 code switches in the transmitter and receivers. The code switches may be set in any random pattern of +, 0 and - positions. Next, in receiver 1, set code switch #7 to + and code switch #8 +; In receiver 2, set code switch #7 to + and code switch #8 to 0. Continue setting the codes in the 831E receivers as shown in the table.

IF YOU ARE USING A 535 STANDARD TRANSMITTER:

This transmitter is used to control up to 27 different doors. This is accomplished by setting the selector switches to either A, B or C and either 1, 2, 3, 4, 5, 6, 7, 8 or 9 and setting the #6, #7 and #8 coding switches in the 831 receiver.

TRANSMITTER
1 - 9 Selector	831 RECEIVER	831 RECEIVER
Switch Position	Code Switch #7	Code Switch #8
1	+	+
2	+	0
3	+	-
4	0	+
5	0	0
6	0	-
7	-	+
8	-	0
9	-	-

Start coding by exactly matching all 8 code switches in the transmitter and receiver. Next, in receiver A1, set code switch #6 to +, set code switch #7 to + and code switch #8 to +; In receiver A2, set code switch #6 to +, set code switch #7 to + and code switch #8 to 0. Continue setting the codes in the 831 receivers, using both tables shown above.

WARNING

DISCONNECT POWER AT FUSE BOX AND DOOR OPENER BEFORE WIRING

PERMANENTLY TO PREVENT ELECTROCUTION.

Page 3 of 4 P/N 107343 Rev D