Alpine CDA-9856 Installation, 30-EN, Accessory List, Install the detachable front panel Removal

Installation

2

Screw

Detachable

Front panel

Caution

When you install this unit in your car, do not remove the detachable front panel.

If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in

Hex Nut (M5)

*2

Metal

Mounting

Strap *1

Ground Lead

Bolt Stud

this unit

place.

Accessory List
•	Head unit	1
•	Power cable	1
•	Mounting sleeve	1
•	Carrying case	1
•	Bracket key	2
•	Screw (M5x8)	4
•	Owner’s Manual	1 set

•The main unit must be mounted within 35 degrees of the horizontal plane, back to front.

Less than 35°

1Mounting Sleeve (Included)

Dashboard

this unit

Remove the Detachable Front Panel (refer to

page 6). Slide mounting sleeve from main unit (see “Removal” on page 30).

Chassis

Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle's chassis.

•For the screw marked “*2”, use an appropriate screw for the chosen mounting location.

Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the CDA-9856. Connect all other leads of the CDA-9856 according to details described in the CONNECTlONS section.

3Slide the CDA-9856 into the dashboard until it clicks. This ensures that the unit is properly locked and will not accidentally come out from the dashboard.

Install the detachable front panel.

Removal

1.Remove the detachable front panel.

2.Insert the bracket keys into the unit, along the guides on either side. The unit can now be removed from the mounting sleeve.

This unit

Bracket keys (Included)

3. Pull the unit out, keeping it unlocked as you do so.

30-EN