1Antenna Receptacle
2Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if applicable.
3Remote
Connect this lead to the remote
4Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+)12V only when the ignition is turned on or in the accessory position.
5Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's battery.
6Ground Lead (Black)
%Left Rear
&Left Front
(Left Front (+) Speaker Output Lead (White)
)Rear/Subwoofer RCA Connectors
RED is right and WHITE is left.
~RCA Extension Cable (Sold Separately)
+DIN Connector
Connect this to the DIN connector on the CD Changer.
,DIN Extension Cable (Sold Separately)
NOTE
Older Alpine CD Changer came with standard, straight type DIN connectors. In installations where an
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.
7Fuse Holder (15A)
8Power Supply Connector
9Right Front (+) Speaker Output Lead (Grey)
!Right Front
"Right Rear
#Right Rear (+) Speaker Output Lead (Violet)
$Left Rear (+) Speaker Output Lead (Green)
To prevent external noise from entering the audio system.
•Locate the unit and route the leads at least 10cm away from the car harness.
•Keep the battery power leads as far away from other leads as possible.
•Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis.
•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine noise suppressors, contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
