Alpine CDE-9850Ri 27

27-EN

01GB06CDA-9854R.fm

ALPINE CDE-9850Ri 68-04123Z56-A (EN)

Installation

Accessory List

•Head unit............................................................................1

•Power cable........................................................................1

•FULL SPEEDTM Connection Cable...................................1

•Mounting sleeve.................................................................1

•Carrying case.....................................................................1

•Rubber Cap........................................................................1

•Hex Bolt..............................................................................1

•Screw (M5 × 8)....................................................................4

•Owner’s Manual..........................................................1 set

•The main unit must be mounted within 35 degrees of the horizontal

plane, back to front.

Removal

1. Remove the detachable front panel.

2. Use a small screwdriver (or similar tool) to push the

locking pins to the “up” position (see above drawing).

As each pin is unlocked, gently pull out on the unit to

make sure it does not re-lock before unlocking the

second pin.

3. Pull the unit out, keeping it unlocked as you do so.

Caution

When you install this unit in your car, do not remove the

detachable front panel.

If the detachable front panel is removed during installation, you

might press too hard and warp the metal plate that holds it in

place.

Slide mounting sleeve from main unit (see

“Removal” on page 27). Slide the mounting sleeve

into the dashboard and fix it with the metal shackles.

Detachable

Front Panel

Less than 35°

Bracket

Rubber Cap

(Included)

Hex Bolt

(Included)

This Unit

Dashboard

Mounting sleeve

(Included)

∗

Metal Mounting Strap

Screw

Bolt Stud

This Unit

Hex Nut (M5)

When your vehicle has the Bracket, mount the long

hex bolt onto the rear panel of the CDE-9850Ri and

put the Rubber Cap on the hex bolt. If your vehicle

does not have the Mounting Support, reinforce the

head unit with the metal mounting strap (not

supplied). Connect all the leads of the CDE-9850Ri

according to details described in the CONNECTION

section.

•For the screw *, provide a proper screw to the chassis installing

location.

Slide the CDE-9850Ri into the dashboard. When the

unit is in place, make sure the locking pins are fully

seated in the down position. This can be done by

pressing firmly in on the unit while pushing the

locking pin down with a small screwdriver. This

ensures that the unit is properly locked and will not

accidentally come out from the dashboard. Install

the Detachable Front Panel.

Lock Pin

Face Plate

Screws (M5 × 8)

(Included)

This Unit

Mounting Bracket

01GB00CDA-9854R.book Page 27 Wednesday, October 19, 2005 8:21 AM