Alpine RUE-4187 specifications Handling Precautions, Battery Replacement, Case of Difficulty

R

RUE-4187

1

25

6 7 8 9

Handling Precautions

Do not drop or apply shock to the unit. It may be get permanently damaged.

Keep the unit away from water and moisture, direct sun and heat, and excessive dust.

Never use scouring pads, steel wool, abrasive powders or harsh chemical agents, such as lye solution, for cleaning.

Clean with a soft, lint-free cloth or cotton swab slightly dampened with a mild solution of detergent and water.

Do not operate this unit in a manner that could distract you from driving safety.

Remote Control Unit

Owner’s Manual

Controls on Remote Control

1	Power Button
	Press the button to turn the power on/off.
2	Source Button
	Press to select the audio source.
3	-/J /Enter Button
	Press the button to switch between the Play and Pause
	modes for CD or MD and Tape.
	Audio Processor Mode: Enter button
	Press this button to adjust the MODE that is called by

3!

"

4

#

8g Button

Radio mode: SEEK (DN) Button

CD/CD changer mode: Press the button to go back to the beginning of the current track.

Tape mode: REW Button

Audio Processor Mode: Press this button to adjust the MODE that is called by pressing the A.PROC button.

9f Button

Radio mode: SEEK (UP) Button

CD/CD changer mode: Press the button to advance to the beginning of the next track.

Tape mode: FF Button

Audio Processor Mode: Press this button to adjust the

Battery Replacement

Applicable battery: Use two “AAA” sized dry batteries or equivalent.

1 Opening the battery cover.	2	Replacing the battery.	3 Closing the cover.
Slide out the battery cover while		Put the batteries in the case observing	Push the cover as illustrated
firmly pressing the direction of arrow.		the polarities as illustrated.	until a click is heard.

In Case of Difficulty Specifications

	pressing the A.PROC button.
4	ANGLE 89 Buttons
	Press the button to adjust the angle of the movable
	display.
5	Band/Program Button
	Radio mode: BAND Button
	Changer mode: BAND Button
	Switches changers (when a Multi-Changer Switching
	device is connected).
	TAPE mode: PROG Button
	Press the button to change between the A and B side
	of the tape.
6	Volume Adjustment Buttons
	To increase the volume level:

MODE that is called by pressing the A.PROC button.

!9 Button

Radio mode: Pressing the button will select, in descending order, stations programed into the radio's

presets as shown below.

→ 6 → 5 ... 1

CD Changer mode: DISC Select (DN) Button

Press the button to select a disc in descending order. Tape mode: Pressing this button enters the Program Sensor Down mode.This allows for music selection towards the beginning of the tape.

Audio Processor Mode: Press this button to adjust the MODE that is called by pressing the A.PROC button.

Problem	Cause	Solution
Remove	Reverse	Place the battery
Control	placement of	correctry into its cradle
Inoperative.	battery.	in the compartment.
	Dead battery.	Replace the battery with
		a new one.
	Remote Control not	Point the remote control
	pointed toward the	directly toward your
	head unit.	head unit.

Battery Type	AAA sized dry batteries
Battery Quantity	2
Dimensions(W x H x D)	42 x 121 x 23mm
	(1-21/32” x 4-25/32” x 29/32”)
Weight (without battery)	50g (1.8 oz)
Accessory	Remote Control Unit Holder

Press the L button

To decrease the volume level:

Press the K button

7 8 Button

Radio mode: Pressing the button will select,

in ascending order, stations programed into the radio's

presets as shown below.

→ 1 → 2 ... 6

CD Changer mode: DISC Select (UP) Button Press the button to select a disc in ascending order. Tape mode: Pressing this button enters the Program Sensor Up mode.This allows for music selection towards the end of the tape.

Audio Processor Mode: Press this button to adjust the MODE that is called by pressing the A.PROC button.

"Mute Button

•Press the button to lower the volume by 20 dB instantly. Press the button again to cancel.

•Press the button for at least 2 seconds to raise the

monitor. Press the button again to lower the monitor. (Head unit with Monitor Display, etc.)

#Audio Processor Button∗∗

Press the button to call the external audio processor mode.∗

∗For the operation of external audio processor, refer to the Owner's Manual of the external audio processor you purchased.

∗∗This button is used in conjunction with an optional Ai-NET processor.

NOTE

Depending on the device you are using, you cannot operate or may need to operate differently some devices on the remote control.

For details, refer to the Owner’s Manual of the device you purchased.

R

ALPINE ELECTRONICS, INC.	ALPINE ELECTRONICS OF AUSTRALIA PTY. LTD.	ALPINE ELECTRONICS FRANCE S.A.R.L.
Tokyo office: 1-1-8 Nishi Gotanda,	6-8 Fiveways Boulevarde Keysborough,	(RCS PONTOISE B 338 101 280)
Shinagawa-ku,	Victoria 3173, Australia	98, Rue De La Belle Etoile, Z.I. Paris Nord Il
Tokyo 141-8501, Japan	Tel.: (03) 9769-0000	B.P. 50016 F-95945, Roissy, Charles De Gaulle
Tel.: (03) 3494-1101	ALPINE ELECTRONICS GmbH	Cedex, France
ALPINE ELECTRONICS OF AMERICA, INC.		Tel.: 01-48 63 89 89
	Kreuzerkamp 7-11 40878 Ratingen, Germany
19145 Gramercy Place, Torrance,	Tel.: 02102-45 50	ALPINE ELECTRONICS OF U.K., LTD.
California 90501, U.S.A.	ALPINE ITALIA S.p.A.	13 Tanners Drive, Blakelands, Milton Keynes
Tel.: 1-800-ALPINE-1 (1-800-257-4631)		MK14 5BU, U.K.
	Via C. Colombo 8, 20090 Trezzano Sul Naviglio
		Tel.: 01908-61 15 56
ALPINE ELECTRONICS OF CANADA, INC.	MI, Italy
		ALPINE ELECTRONICS DE ESPAÑA, S.A.
Suite 203, 7300 Warden Ave. Markham,	Tel.: 02-48 47 81
Ontario L3R 9Z6, Canada		Portal De Gamarra 36, Pabellón 32
Tel.: 1-800-ALPINE-1 (1-800-257-4631)		01013 Vitoria (Alava)-Apdo. 133, Spain
		Tel.: 34-45-283588
		68P01434K62-O
		Printed in China(Y)