Alpine TDM-7580E owner manual Installation, Removal

Installation

1

Mounting sleeve (Included)

Dashboard

TDM-7580E

Remove the Detachable Front Panel (refer to page 4). Slide mounting sleeve from main unit. Slide the mounting sleeve into the dashboard.

3

Lock Pin

Slide the TDM-7580E into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.

2

Hex Nut (M5)

Ground Lead

Metal Mounting

Strap

Screw

Bolt Stud

∗

Removal

1.Remove the Detachable Front Panel.

2.Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

3.Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

Chassis

TDM-7580E

Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.

Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the TDM-7580E. Connect all other leads of the TDM-7580E according to details described in the CONNECTlONS section.

Face Plate

Screw (M5 ⋅ 8) (Included)

Ground Lead TDM-7580E

∗

Mounting Bracket

15-EN