Alpine TDM-7582 owner manual 17-EN

1Antenna Receptacle

2Power Antenna Lead (Blue)

Connect this lead to the +B terminal of your power antenna, if applicable.

NOTE

This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc.

3Remote Turn-On Lead (Blue/White)

Connect this lead to the remote turn-on lead of your amplifier or signal processor.

4Switched Power Lead (Ignition) (Red)

Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+) 12V only when the ignition is turned on or in the accessory position.

5Fuse Holder (15A)

6Battery Lead (Yellow)

Connect this lead to the positive (+) post of the vehicle's battery.

7Ground Lead (Black)

Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.

8Power Supply Connector

9Right Front (+) Speaker Output Lead (Gray)

!Right Front (–) Speaker Output Lead (Gray/ Black)

"Right Rear (–) Speaker Output Lead (Violet/ Black)

#Right Rear (+) Speaker Output Lead (Violet) $ Left Rear (+) Speaker Output Lead (Green)

% Left Rear (–) Speaker Output Lead (Green/Black) & Left Front (–) Speaker Output Lead (White/Black) ( Left Front (+) Speaker Output Lead (White)

) DIN Connector

Connect this to the DIN connector on the CD Changer.

~Rear Output RCA Connectors

RED is right and WHITE is left.

+DIN Extension Cable

NOTE

For some installations, an L-type DIN connector would simplify installation. Use the Alpine 491002 Adapter (Sold Separately) if your changer did not include an L- type DIN.

,RCA Extension Cable (Sold Separately)

17-EN