Alpine TME-M580 owner manual Case of Difficulty, Symptom Cause Solution

In Case of Difficulty

If you encounter a problem, please review the items in the following check list. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer.

Symptom	Cause	Solution
No function or	Car's ignition is off.	Turn the ignition on.
display.	No fuse or blown fuse.	Check the cause and replace the fuse.
	Incorrect connections.	Check connection and remedy.
	Vehicle's battery is weak.	Check the voltage of vehicle's battery.
Unclear picture	Fluorescent tube is exhausted.	Replace the fluorescent tube*.
display.
No picture	Brightness control is set for	Adjust the brightness.
display.	minimum brightness control.
	Incorrect setting of the Input mode.	Switch to the correct mode.
	Protective circuit is on because of	Wait until the temperature inside the vehicle comes down to the
	high temperature.	operating temperature range (45¡C).
	Incorrect or open connection with	Check the connection and remedy.
	the Monitor, AV Interface unit.
Picture color is	Brightness/Color/Tint control are not	Check each control.
poor.	set to the proper positions.
Spots or dotted	Caused by neon signs, high-voltage	Change the location of your vehicle.
lines/stripes	power lines, CB transmitter, other
appear.	vehicle's ignition plugs, etc.
Unit does not	Monitor's power is not turned on.	Turn on the monitor's power.
operate.
Navigation	Navigation systemÕs power is turned	Press the ON/OFF (POWER) button on the navigation systemÕs
screen is not	off.	remote controller to turn the navigation systemÕs power on.
displayed or
navigation
systemÕs remote
controller keys do
not work.

*Replacement of the fluorescent tube is not covered under the warranty. This is a consumable part subject to wear during normal usage.

Page 6