Alpine TMX-R705 owner manual Opening the Monitor Display, Closing the Monitor Display

Opening the Monitor Display

NOTE

The TMX-R705 is a precision device. With careful handling, its performance can be maintained at a high level for a long time.

1 Press the OPEN/CLOSE button of the main unit or press the POWER button, press and hold the OPEN/CLOSE button of the supplied remote control for at least 2 seconds.

The unit beeps 3 times and opens the monitor automatically.

Then the power of the monitor turns on.

NOTES

•Since this is an overhead monitor, the display will be lowered when opened and raised when closed.

If the monitor touches an obstacle while it is being lowered, the unit will stop immediately. Should this occur, remove the obstacle and press the OPEN/ CLOSE button again to close the monitor.

If you press the POWER button or the OPEN/CLOSE button while the monitor is being opened or closed, the monitor stops opening or closing and cannot be closed automatically. In this case, press the POWER button or the OPEN/CLOSE button again to close the monitor.

•When the movable monitor is opened, do not place any object on the monitor and be careful not to bump or apply any pressure to the monitor while it is open. This can cause damage to the mechanism.

•Under low ambient temperature conditions, the display may be dark for a short period of time immediately after the power is turned on. Once the LCD has warmed up, the display will return to normal.

•The TMX-R705 draws minimal current even when its power switch is turned off. If the switched power (ignition) lead of the TMX-R705 is connected directly to the positive (+) post of the vehicle's battery, the battery may be discharged. If this lead is unswitched, it must be disconnected from the battery post should the vehicle be left unused for an extended period of time.

An SPST (Single-Pole, Single-Throw) switch (sold separately) can be added to simplify this procedure. Then, you can simply place it in the OFF position when you leave the vehicle. Turn the SPST switch back ON before using the TMX-R705. For connecting the SPST switch, refer to the Installation.

•After turning the system off, a slight ghost of the image will remain temporarily. This is an effect peculiar to LCD technology and is normal.

•Under cold temperature conditions, the screen may lose contrast temporarily. After a short warm-up period, it will return to normal.

Closing the Monitor Display

NOTE
The TMX-R705 is a precision device. With careful	FR
handling, its performance can be maintained at a high
level for a long time.
1 Press the OPEN/CLOSE button of the main unit
or press the POWER button, press and hold the
OPEN/CLOSE button of the supplied remote
control for at least 2 seconds.
The unit beeps 3 times and closes the monitor
automatically.	ES
Then the power of the monitor turns off.
NOTE
Since this is an overhead monitor, the display will be
lowered when opened and raised when closed.
If the monitor touches an obstacle while it is being
raised, the unit will stop immediately.
Should this occur, remove the obstacle and press the
OPEN/CLOSE button again to close the monitor.
	DE

IT

SE

5-EN