TRITON T1 BOARD
QU I C K IN S TA L L AT I O N GU I D E
MVIP BUS | MVIP Connector | System |
Termination Switch |
| Configuration Switch |
TRITON T1 BOARD
The Triton T1 Board uses the following signaling and framing features:
Signaling: loop start, ground start, E&M immediate start, E&M wink start*
Line Encoding: AMI, B8ZS*
*recommended
MINIMUM SYSTEM REQUIREMENTS:
•IBM/PC AT compatible system with adequate number of
•233 Mhz Pentium processor (or better)
•2 - 4 GB Hard Disk Drive Space (depending on voicemail requirements)
•Windows NT Server 4.0 with Service Pack 4 (or higher) installed
•128 MB RAM
•AltiGen’s Quantum Telephony Board (one or more, Rev. D or higher)
•AltiGen’s Triton T1 Board (one or more)
•AltiWare OE R3.0 (or higher)
•300W/10A CPU Power (minimum required to power AltiGen boards only)
•CSU (Channel Service Unit)
# of AltiGen Boards | # of Slots** | CPU | HDD | |
|
|
|
|
|
1 Triton T1, | 2 PCI, 3 ISA | 233 Mhz | 2GB | |
|
|
|
|
|
1 Triton T1, | 2 PCI, 6 ISA | 300 Mhz | 2GB | |
|
|
|
| |
5 PCI, 10 ISA | 350 Mhz | 4GB |
| |
|
|
|
|
|
# of AltiGen Boards | Power Supply** | Typical Power Supply | ||
|
|
|
|
|
1 Triton T1, | +12V: 4.2 | Amps +5V: 6Amps | 300W/30A@5V/12A@12V | |
|
|
|
|
|
1 Triton T1, | +12V: 8.4 | Amps +5V: 10.8Amps | 400W/40A@5V/16A@12V | |
|
|
| ||
+12V: 14 Amps +5V: 21Amps | 400W/40A@5V/16A@12V |
| ||
|
|
|
|
|
**The above system requirements are for AltiGen components only, and do not take into account requirements for other system components such as motherboard, disk drives, etc.
LED Indicators
GREEN LED | RED LED | Status |
|
|
|
OFF | OFF | No power |
ON | OFF | Normal operation |
OFF | ON | No signal |
ON | Flashing | Faulty signal with frame synchronization*** |
OFF | Flashing | Faulty signal without frame synchronization |
Alternating | Alternating | Frame slips in normal operation |
*** Faulty signals include the following: yellow alarm, bipolar violation or frame error
