DISTRIBUTION AMPLIFIERS
INSTALLING YOUR DISTRIBUTION
AMPLIFIER | 6 |
Step 1. Make sure that the power input is set to the proper AC voltage in your country. An incorrect setting can result in equipment damage not covered by warranty. If the power input voltage needs to be changed, remove the fuse portion of the power entry module and change the location of the fuse. Note that the correct voltage is visible through the voltage designation window.
Step 2. Connect the power cord to the unit and plug it into the power outlet. The power indicator LED on the front and back panel will light. This indicates that the unit is operational.
Step 3. Connect a cable from the computer to the input channel of the amplifier. Then connect the output channels of the amplifier to the display devices (i.e. monitors or projector)
Step 4. If the image is less than perfect check all the connections. The unit is very reliable and seldom will this be the cause of malfunction. Poor quality cables may often degrade the performance of the product. Make sure that the cables used are coaxial cables and that all pins are in good condition.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
OPERATION | 7 |
The settings of the DA1406WM Distribution Amplifier can be adjusted using Boot switches as described in Section no. 4. There are no other adjustments necessary to operate the unit. The DA1406WM will operate successfully as long as cables are attached properly and other specifications are followed.
6
