SWITCHERS
The front panel of the MX2416RM provides access to essentially all of the switcher’s capabilities. In addition to standard switching functions, the unit has control and switching functions that could be very useful in a variety of special applications.
4.1 SELECT INPUT
When buttons 1 through 6 are pressed, the corresponding INPUT will be selected and displayed. LED’s on the front and rear panel will light simultaneously to indicate which selection has been made.
4.2 AUTO SWITCH MODE BUTTON
This function is
4.3 STAND BY / ALL CHANNELS OFF BUTTON
This function allows a user to turn OFF all input signals. It is very useful when the MX2416RM Switcher is used in applications where there is a need to turn the display or the source OFF. Press this function key (F2) to switch to a no signal condition. The LED next to the F2 function key will light to indicate that the switcher is in this mode. To
resume input select switching, simply press the desired INPUT.
4.4 RESET BUTTON
This function allows a user to RESET the switcher without unplugging the unit. Press the function key RESET (F3) and hold it for 2 seconds. When you hear a beeping sound, release the key. All of the LED’s will flash simultaneously. The switcher is now reset. All previous defaults, such as power on channel default and other user settings are maintained.
4.5 BEEP ON/OFF BUTTON
This function allows a user to have audible feedback when buttons are pressed. The factory default is beep ON; however, in some applications, sound may be undesirable. To disable sound, press this function key (F4) and hold it for approximately 2 seconds until a beeping sound is heard. The function is now disabled. To enable it, repeat the same steps. The setting is stored in the memory and is maintained during power up sequence.
5
