Altinex TNP100AU manual Operation, Frequently Asked Questions FAQ, Cables and Accessories

ACCESSORIES

OPERATION 7

7.1HOW TO RELEASE AND REPLACE THE GAS SPRING

To replace the spring, push up, and turn the knob in the center on the bottom of the TNP100AU by 90 degrees, thereby releasing the gas spring.

Unscrew the knob, and then unscrew the gas spring itself from the TNP100AU. Replace the gas spring with a new one by screwing it in, and then replacing the knob.

Re-engage the new gas spring by pushing up, and turning the knob by 90 degrees. After you have finished this step, you have completed the installation.

Under normal conditions the gas spring will last up to five years.

FREQUENTLY ASKED QUESTIONS (FAQ) 8

No:	Question	Answer
1	Why are the	Female cables are more
	VGA connectors	reliable.
	female on both
	ends of the
	cables?

2Why is there a The DB-9 connector is DB-9 connector? compatible with RS-232

		serial communication.
3	What happens if	The unit will not stay
	the spring	open.
	breaks?
4	What do I do if	Replace the gas spring.
	the TNP100AU	Call ALTINEX for service
	won’t stay open?	information.
5	How much room	The unit is 4.5 inches
	is taken up on	deep maximum below
	the underside of	the table; to this
	the table?	dimension add about 2.5
		inches for cable
		clearance.
6	What if my table	Then the area under the
	is thicker than 3	table near the
	inches?	TNP100AU must be
		reduced to 3 inches of
		thickness.
7	Are cables	Consider using
	available for	MS8126CA (3ft) or
	connecting a	MS8156CA (6ft) for VGA
	PC/laptop to the	connection.
	TNP100AU
	available?
8	Does ALTINEX	Anything modified by
	honor any	non-ALTINEX personnel
	warranty on field	is not covered by
	modifications?	warranty.

CABLES AND ACCESSORIES 9

10