ALVIN Satin-Glow Lightboxes
Instructions for Cutting Glass
•
MODEL No. | Cut Glass to This Size |
LB1218 | 11 15⁄16" x 17 15⁄16" |
LB1620 | 15 15⁄16" x 19 15⁄16" |
LB1824 | 17 15⁄16" x 23 15⁄16" |
LB2436 | 23 15⁄16" x 35 15⁄16" |
IMPORTANT NOTE
It is highly recommended that these dimensions be
* It is best to purchase glass from a glass dealer rather than a hardware or home center.
Care and Use Instructions
1.To install glass, remove the two aluminum strips on the top surface of the lightbox. For your own safety, use gloves when handling glass. Place the glass on top of the Plexiglas sheet and replace the aluminum strips.
2.To operate, depress the on/off switch and hold for one or two seconds until the lights illuminate. Note: Bulbs may loosen during shipping. If bulbs don’t illuminate check that they are properly seated in fixture.
3.The
4.Removal of the back panel or tampering with the electrical circuitry will void the warranty and releases the manufacturer from all responsibility for damages, loss of property and/or personal injury.
To Replace Fluorescent Tubes
1.“Daylight” bulbs with CRI of 70 or greater are recommended. Always use direct replacement lamps in order to prevent overheating.
2.Disconnect the power cord.
3.Remove the screws and aluminum strips from the top surface of the lightbox. Carefully remove glass and Plexiglas panels.
Degrees of Illumination
MODEL No. | Lumens | Tubes | Lumens at | |
| per Tube | per Box | Light Box Surface | |
LB1218 | 650 | 1 | F15T8 | 650 |
LB1620 | 650 | 2 | F15T8 | 1300 |
LB1824 | 650 | 2 | F15T8 | 1300 |
LB2436 | 1750 | 3 | F30T8 | 5100 |
All electrical components are U.L. listed.
4.Remove the
5.Remove and replace fluorescent tubes.
6.Return diffusers, glass and Plexiglas panels to their original positions.
Alvin & Company, Inc. | Bloomfield, CT | Grand Prairie, TX | www.alvinco.com |