Alvin X-3-XB, X-4-XB manual Professional Spacesaver, Parts Included, To Assemble, Folding Table

	Professional Spacesaver
	Assembly Instructions X1-3-XB, X1-4-XB, XII-3-XB. XII-4-XB
		For models X-3-XB, X-4-XB,
Tools Required: Phillips screwdriver, drill with 1/16" bit.
Parts Included:	B 1pc Tabletop	C 2pcs Rear Extension Tubes
A 1pc Leg Frame	(Shipped in
	separarate box)
		D 2pcs Front Extension Tubes	E 2pcs Floor Glides
		F 2pcs Height	H 12pcs 1/2"
		Adjustment Knobs
			Wood Screws
		G 2pcs Leg Support Braces
To Assemble:		½" Screws

1Unpack all parts and inspect to confirm that all are present.

2 Unfold base (A).

3Insert rear extension tubes (C) completely into frame (A) and loosely hand-tighten knobs (F).

4 Insert front extension tubes (D) into frame (A).

5Place table top (B) with preferred side facing down on carpeted or protected floor. Place supplied cardboard template on board surface with edge of template at front edge of board. Left and right edges of

template should be an equal distance from each side of the table top. Using a 1/16" drill bit, gently drill ¼" deep holes where indicated on the

template (red squares for 24" x 36" top or black holes for 31" x 42"; Figure 1 template marked XB-II is for 36" x 48" top). Remove template.

Wrap masking tape ¼" from drill bit end to determine drilling depth. TIP Take care to drill only ¼" deep to avoid drilling through and damaging

table top surface.

6Using the Phillips screwdriver, screw the leg support braces (G) onto the tabletop (B) as shown in Figure 1.

7Carefully turn table frame upside down and place on top of tabletop. Align holes in front leg extensions (D) with holes in table

top as shown in Figure 1. Fasten all ½" screws (H) and tighten securely. Use care not to overtighten and strip.

8	Carefully return table assembly to the upright position. Adjust table
	top to desired height using height adjustment knobs (F).

You’re finished and your table is ready to use as shown in Figure 2.	Figure 2
Folding Table:

Drop all extension tubes down to their lowest positions. Lift top up until the front extension tubes (D) disengage with the support braces (G), then move the left leg assembly in until it is flush against the rear frame assembly. Next move the right leg assembly in flush against the left leg assembly. Gently lower the table top down flush against the right leg assembly.

The table is now ready for storage.

Professional Spacesaver Models

X-3-XB	XI-3-XB	XII-3-XB
X-4-XB	XI-4-XB	XII-4-XB

©2008	ALVIN & COMPANY, INC. • P.O. Box 188, Windsor, CT 06095-0722	www.alvinco.com
Phone:	860-243-8991 • Toll-Free: 800-444-2584 • Fax: 860-242-8037 • Toll-Free Fax: 800-777-2896	LIT-A8002 4/08