Amana ADB1000AW dimensions Undercounter Dishwasher, Product Model Numbers, Overall Dimensions

Undercounter Dishwasher

PRODUCT MODEL NUMBERS

OVERALL DIMENSIONS

ADB1000AW

Electrical: 120-volt, 60 Hz, AC-only, 15 or

20 amp. electrical supply. Use copper wire only. A time-delay fuse or circuit breaker and separate circuit is recommended.

Water: A hot water line with 20-120 psi

(138-862 kPa) water pressure. Water temperature must be 120°F (49°C) at dishwasher. Use 3/8" O.D. copper tubing with compression fitting (1⁄2" minimum plastic tubing is optional but not recommended). Use a 90° elbow with 3⁄8" N.P.T. external pipe threads on one end to connect to

24" (61 cm)*

337⁄8"

(86 cm) min.

*to front of door frame

203⁄4" (52.7 cm)

237⁄8" (60.6 cm)

water inlet valve. Do not solder within 6" (15.2 cm) from water inlet valve.

Drain: Use the new drain hose supplied with your dishwasher. If this is not suitable, use a new drain hose with a maximum length of 12 feet (3.7 m) that meets all current AHAM/IAPMO test standards, is resistant to heat and detergent, and fits the drain connector of the dishwasher. Must have a high drain loop 20" (50.8 cm) above the subfloor or floor. Connect drain hose to waste tee or disposer inlet above drain trap in house plumbing and 20"

(50.8 cm) minimum above the floor. An air gap must be used if the drain hose is connected to house plumbing lower than 20" (50.8 cm) above subfloor or floor. Use 1⁄2" minimum I.D. drain line fittings.

Corner location: Requires a 2" (5.1 cm) minimum clearance between the side of the dishwasher door and wall or cabinet.

A side panel kit is available from your dealer for installing your dishwasher at end of cabinet.

Grommet is required for electrical cable or power supply cord hole cut in a metal cabinet.

Do not install dishwasher over carpeted floor.

CABINET OPENING DIMENSIONS
	24" (61 cm)**
* Measured from the lowest point on the
underside of countertop. May be reduced
to 337⁄8" (86 cm) by removing wheels from
dishwasher.
** Minimum, measured from narrowest point
of opening.		24" (61 cm)		34" (86.4 cm) min.*
	6"(15.2 cm)	6"(15.2 cm)
	4" (10.2 cm)
4"			4"
			(10.2 cm)
(10.2 cm)
21⁄2"	10"		21⁄2"
(6.4 cm)	(25.4 cm)		(6.4 cm)
2"	5" (12.7 cm)	5" (12.7 cm)	2"
			(5.1 cm)
(5.1 cm)

Water line entering through the	Drain hose and power supply line entering through the right
left side of opening in shaded	side of opening in shaded areas makes connection easier.
areas makes connection easier.	Drain hose size: 11⁄2" (3.8 cm)
Minimum 1⁄2" (12,7 mm) hole.	Power supply line hole-direct wired: 3⁄4" (1.9 cm)
	Power supply line hole-with plug: 11⁄2" (3.8 cm)

CUSTOM FRONT PANEL DIMENSIONS (Framed)

7⁄32"

These panels fit only models with frames around the door and access panels.

Cut door panel to clear access panel when door is in open position .

door closed

(5.6 mm)

door panel (side view)

7⁄32"

(5.6 mm)

door panel (front view)

3⁄8"

(9.5 mm)

	18	21⁄32"
1"	(47.4	cm)
(25.4 mm)

2231⁄32"

(58.3 cm)

NOTE: Access panel is wider than door panel.

235⁄16" (59.2 cm)

access panel (front view)

All edges routed to 7⁄32" (5.6 mm) thickness.

side view

door pivot

door opened

access panel

7⁄32" (5.6 mm) thick

top view

access panel frame 1⁄4"

(6.4 mm) min.

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation	Ref. 8535436-D-AM
Instructions packed with product. Specifications subject to change without notice.	07/06/09