Amana AKT3650 Cooking on the Smoothtop, Setting Surface Element Controls, Dual Surface Elements

Cooking on the Smoothtop

If These Features are Different from Yours

These examples are intended to show the variety of features that are available in the product line. If your cooktop does not have all the options that are shown, it is not a mistake. The information provided applies to several of the models in the product line.

Setting Surface

Element Controls

Push and turn the surface element control knobs in either direction to turn on the surface elements. The outer edge of your pan should always cover the element graphic, with a maximum overhang of

1 inch. Surface elements are located under the ceramic cooking surface and radiate heat through the cooktop. The controls have infinite settings between LO and HI for fine temperature control.

IH

l

6

l

5

l

FFO

O

L

l

2

l

3

l

4

Cooking Safely with

Surface Elements

!WARNING

To avoid risk of serious personal injury, property damage, or fire, do not leave surface elements unattended while in operation. Grease and spillovers can ignite causing a fire.

!WARNING

To avoid risk of electrical shock or serious personal injury,

•never cook on a broken smoothtop cooking surface. Spillovers can penetrate broken surface and cause electric shock.

•never clean broken cooktop.

Cleaners can penetrate broken surface and cause electric shock.

If smoothtop cooking surface breaks, discontinue use and contact an authorized servicer immediately.

!WARNING

To avoid serious personal injury, do not use a damp or wet cloth to clean up spills on a hot or warm cooktop. Moist or damp cloths on hot surfaces may result in burns from steam.

1.Push in and turn surface element control to desired setting.

•You will see the element turn on and off while you are cooking. This is the element cycling to maintain proper temperature.

2.When finished cooking, turn control to OFF position.

Dual Surface Elements		OL
		FFO
Dual surface elements have an inner and outer	I	H
element that can be set according to the pan size.
The outer edge of your pan should always cover
the element graphic, with a maximum overhang of		H	I
1 inch. To use inner and outer element
	M
		E
		D
simultaneously, push and turn knob to double lined		LO

side of knob and desired heat setting. To use inner

element only, push and turn knob to single line side of knob and desired heat setting. When finished, turn control to OFF position.

SURFACE ELEMENT
CONTROL SETTINGS	WHEN TO USE SETTING
LO	Use to prepare food at less than boiling
	temperatures or to simmer.
MED	Use to maintain boiling of larger amounts of food,
	low temperature frying.
HI	Use to bring food to boiling temperatures. When
	food is boiling temperature setting should be
	reduced to LO through MED.

Indicator Lights

Surface elements are indicated by an indicator light that glows when the element is turned on. The location and number of indicator lights vary with each model. After a surface control is turned off, the surface indicator light will continue to glow until surface temperature has cooled to approximately 145°F. The length of time the light remains on will vary. If there is more than one surface element light, do not expect the lights to shut off at the same time.

After you cook...

...remember to establish a cleaning routine for your smoothtop. Cooktops can be sensitive to certain cooking spillovers. Unlike conventional cooktops, smoothtops should not be cleaned with a wet dishcloth when wiping down other counters. Daily care is quick, easy and can prevent damage. To purchase Amana recommended cleaning products, contact our Consumer Affairs department

at (800) 843-0304.

6