8
Installing your refrigerator, cont.

REMOVING PANELS

1. Remove top trim screws with a
Phillips screwdriver and remove top
trim.
IMPORTANT: Tape tops of panels to
door to prevent panels from falling.
2. Slide handle upward until
loose. Remove handle
from door.
3. Remove door
retainer clips with
a 1⁄4" hex head
driver.
4. Remove tape to slide panels out of
door trim.
5. Refer to steps 5, 6 and 7 of
Installing Panels to install handles
and trim.
How to install andremove panels
(SELECT MODELS)
To avoid possible injury and damage
to property, tape decorative panels
(select models) securely into place
when door handles are removed.
WARNING
To avoid personal injury or
property damage, observe the
following:
➢Refrigerator panels should not
weigh more than 30 pounds (14
kilograms) and freezer panels
should not weigh more than 15
pounds (7 kilograms).
➢Protect soft vinyl or other flooring
with cardboard, rugs or other
protective material.
➢Protect hands and arms by
wearing gloves.
CAUTION
NOTE:
➢To protect door surfaces from being
scratched, cover back edges of
decorator panels by placing masking
tape along back edges.
➢Save all screws and reuse in original
locations.
Extended
Door
Panel
Fresh food
door
Upper
dispensing
freezer door
Lower
dispensing
freezer door
Non-
dispensing
freezer door
Panel
Height
66 3⁄4"
(169.5 cm)
18 1⁄8"
(46 cm)
32 3⁄32"
(81.5 cm)
66 3⁄4"
(169.5 cm)
Panel
Width
18 15⁄16"
(48.1 cm)
13 15⁄16"
(35.4 cm)
13 15⁄16"
(35.4 cm)
13 15⁄16"
(35.4 cm)
1⁄4" (6 mm) Panel Dimensions

INSTALLING PANELS

1. Remove top trim screws with a
Phillips screwdriver and remove top
trim.
2. Slide handle upward until
loose. Remove handle
from door.
3. Remove door
retainer clips with
a 1⁄4" hex head
driver.
4. Slide bottom of panels into bottom
door trim until hinge side of decorator
panel rests under hinge side trim.
IMPORTANT: Tape tops of panels to
door to prevent panels from falling.
5. Reinstall door
retainer clips with
a 1⁄4" hex head
driver.
6. Reinstall handle by inserting retaining
clips on door into notches on back of
handle.
➢Slide handle down until it contacts
bottom trim.
7. Remove tape from
tops of panels
before reinstalling
top door trim with
Phillips screws
removed in step 1.