®
Front Loading Washer
PRODUCT MODEL NUMBERS
NFW7200T
Electrical:
Water: Pressure of 20 to 120 p.s.i. (138 to 827 kPa) is required.
Hot and cold water faucets must be within 4 ft
(1.2 m) of the back of the washer for inlet hoses.
NOTE: Inlet hoses are available in lengths up to
10 ft (3m) for faucets more than 4 ft (1.2 m) from the washer.
PRODUCT DIMENSIONS
A. Overall height: 38" (96.5 cm)
B. Width: 27" (68.6 cm)
C. Depth with door open 90°: 49" (124.5 cm)
D. Depth: 28" (71.1 cm)
NOTE: The height of the washer from the floor is 38" (96.5 cm). This includes the leveling leg screwed all the way in. The leg can be unscrewed an additional 7/8" (2.2 cm) for a total overall height of
LOCATION CONSIDERATIONS
It is recommended that the washer never be installed in areas where water may freeze since the washer will always maintain some water in the water valve, pump and hose areas. This can cause damage to belts, pump, hoses and other components.
Operating temperature should be above 60° F.
Alcove or closet installation:
Minimum clearances for closet and alcove installations:
Sides | 0" (0 cm) | Rear | |
Top | 0" (0 cm) | Closet front | 2" (5.1 cm) |
The closet front must have a total unobstructed air opening of 72"2 (465 cm2) minimum, if both washer and dryer are installed together. A louvered door with equivalent air opening is acceptable. Washer alone does not require specific air opening.
DRAIN SYSTEM OPTIONS
The standpipe or laundry tub must be at least 18" (45.7 cm) high and no higher than 96" (2.4 m). The standpipe must be large enough to accept the outside diameter of the factory- attached drain hose.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation | Ref. W10161756 |
Instructions packed with product. Specifications subject to change without notice. |
