emptying the water tank
When the water tank is full, the unit will switch off automatically and beep 15 times, the LED [2] will light up.
-hold the top and bottom center of the tank with both hands and pull it out gently.
-after having emptied the tank, gently push the tank back into its place. The LED light will go off.
Warning:
1.Do not remove the float from the water tank. The tank full sensor will no longer be able to detect the water level correctly without the float and water may leak from the water tank.
2.If the tank is dirty, wash it with cold or lukewarm water. Do not use detergent, scouring pads, chemically treated dust cloths, gasoline, benzene, thinner, or other solvents, as these can scratch and damage the tank and cause water leakage.
3.When replacing the drainage tank, press the tank firmly into place with both hands. If the tank is not positioned properly, the “TANK FULL” sensor will be activated, and the dehumidifier will not operate.
continuous drainage
For the continuous drainage please follow these points:
1. Switch off the unit and remove the plug from the electrical outlet.
2. Remove the rubber stopper.
3.Connect a drain tube (10 mm inner diameter) on the drainage port.
4.Place the other end in a drain. Make sure the tube is free from twists and bends.
Note: The water tank must always be in place, even during continuous drainage.
