BASIC OPERATION (CONT.)
13. Loop Play
•Press the LOOP button to set the loop start point A, the LOOP indicator will flash on the LCD.
•Press the LOOP button again to set the loop end point B. After the B point is set the playback will enter the loop play from A to B repeatedly.
•Press the LOOP button again, the loop play function is canceled, the LOOP indicator goes out.
BEFORE SWITCHING OFF THE POWER
When you have finished using the CD player, before switching off the power be sure that the disc holder has been closed with the OPEN/CLOSE button (Figure 15).
CAUTION: Do not forcibly close the disc tray when the power is off.
Fig. 15
Do not switch off the power when | Switch off the power after the disc holder has |
the disc holder is open. | been closed with the OPEN/CLOSE button. |
COMPACT DISCS
1.Precautions on handling compact discs
•Do not allow fingerprints, oil or dust to get on the surface of the disc. If the disc is dirty, wipe it off with a soft dry cloth.
•Do not use benzene, thinner, water, record spray,
•Always handle discs carefully to prevent damaging the surface; in particular when removing a disc from its case or returning it.
•Do not bend the disc.
•Do not apply heat.
•Do not enlarge the hole in the center of the disc.
•Do not write on the label (printed side) with a
•Condensation will form if a disc is brought into a warm area from a colder one, such as outdoors in winter. Do not attempt to dry` the disc with a hair dryer, etc.
2.Precaution on storage
•After playing a disc, always unload it from player.
•Always store the compact disc in the jewel case, protecting from dirt or damage.
•Do not place discs in the following areas:
a)Areas exposed to direct sunlight for a considerable time.
b)Areas subject to accumulation of dust or high humidity.
c)Areas affected by heat from indoor heaters, etc.
REV 3/01
American audio •