FRONT PANEL | 1 | 2 | 3 | 4 |
| |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5
6
7
Diagram 1
11 | 8 |
|
1. Channel 1 Signal indicator -
This Green LED will glow when there is an input signal present.
2. Channel 1 Protect indicator -
This red LED will glow when channel one goes in to protect mode. In protect mode the output signal to the speakers will terminated to channel one.
3. Channel 1 Clip indicator -
This LED comes on at the amplifiers clipping point, the point when the output signal begins to distort. Under heavy clipping lower the input gains (Diagram 8) to reduce the risk of damage to your speakers and amplifier.
4. Power LED -
This LED will glow when the amplifier is turned on, indicating power is going to the unit.
5. Channel 2 Clip indicator -
This LED comes on at the amplifiers clipping point, the point when the output signal begins to distort. Under heavy clipping lower the input gains (Diagram 10) to reduce the risk of damage to your speakers and amplifier.
9
10 | 11 |
| |
6. Channel 2 Protect indicator - |
|
This red LED will glow when channel two goes in to protect mode. | |
In protect mode the output signal to the speakers will terminated | |
to channel two. |
|
7. Channel 2 Signal indicator - |
|
This Green LED will glow when there is an input signal present. | |
8. Channel 1 Gain control - |
|
This knob adjust the channel one volume output to the speakers | |
connect to channel one. |
|
9. Power Switch - |
|
This switch turns the unit on. |
|
10. Channel 2 Gain control - |
|
This knob adjust the channel one volume output to the speakers | |
connect to channel one. |
|
11. Exhaust Cooling Vents - |
|
A cooling fan is mounted at rear of the amplifier. These exhaust | |
vents allow hot air to be pushed out of the amplified to allow | |
ample cooling of the internal components. Do Not Block These | |
Vents! |
|
V1500™ Power Amplifier Instructions page 4
