American Audio V3000/V2000 manual Inputs, Limiter, Low Cut Filter, OUTPUTS Banana Jack Connection

2 ON=30Hz

OFF=50Hz

Low

Cut Filter

INPUTS

Two input connector, XLR jack for balance and 6.3mm (1/4”) TRS jack for unbalance.

INVERTING INPUT -

•BALANCED

GROUND

•UNBALANCED GROUND

•SYMETRIQUE

•SYMMETRISCHE

•BALANCEADO

NON-INVERTING INPUT +

•ASYMETRIQUE

•UNSYMMETRISCHE

•UNBALANCEADO

NON-INVERTING INPUT +

OUTPUTS (Banana Jack Connection)

Strip back insulation 13-mm. Insert wire fully, tighten barrel.

13mm

1/2”

LIMITER

The limiter has a fixed threshold and will prevent continuous clipping. Below clipping, and during short clips on peaks, the limiter does not act on the audio signal. The limiter for either channel can be disabled independently using the slide switch on the front panel.

LOW CUT FILTER

OFF

ON

1 2 3 4

CH. 1

The low-cut filter removes ultra-low frequency information from the audio signal 1 that could damage or cause distortion in a loud speaker system. The dip switch on the rear panel allows you to enable or disable the filter independently for either Channel, as well as set it for either a 50Hz or 30 Hz cut-off. Always use

the 50 Hz filter setting if you are using the amplifier to drive a distributed line system (also a constant-voltage line, 70 volt line, etc.)

CH.2

3ON=30Hz

OFF=50Hz

4Low Cut Filter

known as

Page 6 • American AUDIO V3000 / V2000 MK II Power Amplifier Instructions