GAS VALVE/IGNITION SYSTEM COMPONENTS | TUMBLER SUPPORT | |||
|
|
|
| WHEEL ASSEMBLY REPLACEMENT: |
|
|
|
| |
|
|
|
| The front wheel assemblies can be replaced with |
| IGNITOR |
|
| the lower front panel removed. Remove the three |
|
|
|
| bolts by reaching upward with a socket or box |
|
|
|
| wrench. The illustration below is provided to show |
|
|
|
| the location of these wheels as the wheels cannot |
|
|
|
| easily be seen while standing in front of the dryer. |
BURNER TUBE
GAS VALVE
OVEN HOUSING COMPONENTS
OVEN CHAMBER |
HEAT SENSOR |
BURNER |
The left rear wheel assembly can be removed with just the back guard removed. The rear right wheel requires removing the back guard, heat duct, and oven. Be sure to mark the position of rear wheel brackets prior to removal (refer to page 7).
All wheel assemblies are mounted on slots to allow for alignment of the tumbler. After one or more wheel assemblies are replaced, the tumbler must be realigned.
6 | American Dryer Corp. |
