OVEN CHAMBER REMOVAL:
The oven chamber can be removed after the gas valve/ignition system has been removed.
Remove the two screws indicated by the arrows. Pull the oven housing part way out through the front and disconnect all wire connections. The oven housing can now be removed.
Replace assembly by leading the housing cone into the hole in the rear wall. Replace screws and wire connections.
OVEN HOUSING COMPONENTS:
OVEN CHAMBER |
HEAT SENSOR |
BURNER |
TUMBLER SUPPORT
WHEEL ASSEMBLY REPLACEMENT:
The front wheel assemblies can be replaced with the lower front panel removed. Remove the three bolts by reaching upward with a socket or box wrench. The illustration below is provided to show the location of these wheels as the wheels cannot easily be seen while standing in front of the dryer.
GAS VALVE/IGNITION SYSTEM COMPONENTS:
IGNITOR 
BURNER TUBE
GAS VALVE
The left rear wheel assembly can be removed with just the back guard removed. The rear right wheel requires removing the back guard, heat duct, and oven. Be sure to mark the position of rear wheel brackets prior to removal (refer to page 7).
6 | American Dryer Corporation |
