Notice
Clean the Sprayer IMMEDIATELY after use. Delayed or inadequate cleaning will permanently clog the
Spray Gun. Warranty void if sprayer is not properly cleaned immediately after every use.
8.Remove Suction Tube from water or flushing solvent and submerge in paint pail.
11.Turn Spray/Prime Switch to Spray mode and continue to spray into waste bucket.
9. Switch Power to On.
12. Stop spraying and activate trigger lock.
10.Paint should work itself from Suction Tube to Sprayer to Return Tube until paint discharges from Return Tube. Point gun into waste bucket and pull trigger.
13.Remove the Return Tube from the waste bucket and clip to Suction Tube and submerge in paint pail.
14.If the motor stops, the pump and tubes are primed. If it does not stop, repeat priming steps.
15.Start Painting.
SKU 68001 | For technical questions, please call | Page 13 |
