5.Status Indicators
The MasterSwitch™ has eight receptacle status LEDs located on the front panel. When a status LED is on, it indicates the related recep- tacle has power; When a status LED is off, its receptacle does not have power.
The MasterSwitch™ also has two network connection status LEDs, also located on the front panel, that indicate the following states:
L E D | S t a t e | I n d i c a t i o n | |
|
|
| |
| B l i n k i n g | M a s t e r S w it c h ™ is c o n n e c t e d t o a w o r k in g | |
L i n k - T X / R X | G r e e n | n e t w o r k . | |
|
|
|
|
| O f f |
| N e t w o r k o r M a s t e r S w it c h ™ c o n n e c t i o n f a i lu r e . |
|
|
|
|
| S o lid | G r e e n | M a s t e r S w it c h ™ is o k . |
|
|
| |
| B lin k in g | N e t w o r k c o n f ig u r a t io n v a l u e s h a v e n o t b e e n | |
S t a t u s | G r e e n | d e f in e d f o r t h e M a s t e r S w i t c h ™ . | |
|
|
| |
| F la s h in g | P r o c e s s i n g b o o t p . | |
| R e d | ( S lo w ) |
|
|
|
|
|
| S o lid | R e d | H a r d w a r e F a i lu r e . |
|
|
|
|
Table 1: Network Connection
6.Initial Setup
Before the MasterSwitch™ can operate over the network it needs to have certain address values defined. These values can be set (config- ured) by a BOOTP server (the MasterSwitch™ comes with BOOTP enabled) or by using a terminal (or terminal emulator) connected to the
NOTE: Refer to the MasterSwitch™ - User’s Guide for information on the initial configuration of the MasterSwitch™ . A copy of this guide, in portable data format is provided on the diskette that came with the MasterSwitch™ .
In addition, if you want to use SNMP to configure and control the MasterSwitch™ , you will need to load and compile APC’s Master-
NOTE: The
6
