American Standard 0291.004 dimensions Retrospect Collection Countertop Sink, To Be Specified

BARRIER FREE

RETROSPECT COLLECTION® COUNTERTOP SINK

FINE FIRECLAY

RETROSPECT COLLECTION®

COUNTERTOP SINK

•Classically-styled countertop sink

•Retrofits in any 20" x 17" cutout

•Made from fireclay china

•Front overflow

•Self-rimming with cutout template supplied

•Part of design matched Retrospect Collection®

❏0291.004 Faucet holes on 4" (203mm) centers

❏0291.008 Faucet holes on 8" (102mm) centers (illustrated)

Nominal Dimensions:

584 x 457mm (23" x 18")

Bowl sizes:

422mm (16-5/8") wide 286mm (11-1/4") front to back 159mm (6-1/2") deep

Compliance Specifications - Meets or Exceeds the Following Specifications:

•ASME A112.19.9M for Non-Vitreous Ceramic Fixtures

•CAN/CSA B45 Series

203mm
(8")
FINISHED WALL		51mm
OR SPLASHBACK	OPTIONAL	(2)
3 Holes
1-3/8" (35mm) Dia.
224mm
(8-7/8")	457mm
	(18")
	400mm
1-3/4" DIA.	(15-3/4")
STD. DRAIN
OUTLET
		845mm
		(33-1/4)
584mm
(23")		686mm
		(27)
SEALING COMPOUND		MIN.
(BY OTHERS)
COUNTERTOP	19mm
	(3/4")
(BY OTHERS)

		197mm
*254mm		(7-3/4")
(10")
*295mm	203mm
(11-5/8")		SUPPLIES
	(8")	AS REQ'D 178mm
		(7")

610mm

(24)

203mm DRAWING FOR

(8)DIMENSIONAL

MIN.	PURPOSES ONLY.
	IT IS NOT AN EXACT
	REPRESENTATION.

152mm

(6)

MAX.

BARRIER FREE

CLEARANCE 229mm

(9)

MIN.

To Be Specified:

❏Color: White only

❏Recommended Faucet: 2373.701

❏Faucet Finish:

❏Supplies:

❏1-1/4" Trap

1-1/4 O.D.

WASTE

1-1/4" O.D.	787mm (31)
TAILPIECE
	845mm (33-1/4)

FINISHED FLOOR

MEETS THE AMERICAN DISABILITIES ACT GUIDELINES AND ANSI A117.1 ACCESSIBLE AND USABLE BUILDINGS AND FACILITIES - CHECK LOCAL CODES.

Install lavatory 864mm (34") from finished floor.

Lavatory installed 51mm (2") minimum from front edge of countertop provides 686mm (27") knee clearance area.

© 2008 AS America Inc.

NOTES:

*DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE SUGGESTED.

FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE TEMPLATE SUPPLIED WITH SINK.

FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.

SEALING COMPOUND SUPPLIED BY OTHERS.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.9M.

These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

J31

Revised 5/06