American Standard 2000.10X Test Installed Fitting, Check Drain Connections, If Faucet Drips

10 TEST INSTALLED FITTING
With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.	4	1

Remove AERATOR (3).

Operate HANDLE (1) to flush water lines thoroughly.

Replace AERATOR (3).

CHECK DRAIN CONNECTIONS

Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK. If DRAIN STOPPER (5) does not seal properly, please refer to Troubleshooting section in these instructions.

Release POP-UP KNOB (4) down and check all drain connections and "P" trap for leaks. Tighten

if necessary.

3

5

WASTE

OUTLET

2

2 “P” TRAP

11 SERVICE

HOT LIMIT SAFETY STOP

By restricting handle rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY STOP reduces risk of accidental scalding. To set the maximum hot water temperature of your faucets, all you need

to do is adjust the setting on the HOT LIMIT SAFETY STOP.

Remove necessary trim parts. Use a flat blade screwdriver or pull forward with your fingers to rotate red HOT LIMIT SAFETY STOP. Follow Step "A" or "B" to adjust max./min. discharge temperature. "0" being the hottest to "7" the coldest

temperature setting. "A"

IF FAUCET DRIPS

If faucet drips, operate handle several times from "off" to "on". Do not apply excessive force.

Clogged CARTRIDGE inlets may cause reduced flow in "full on" hot or cold. To clean inlets, first turn off water supply, then:

Remove HANDLE (1), CAP (2), SCREWS (3) and CARTRIDGE (4). Clean inlets and MANIFOLD (5).

Reassemble CARTRIDGE (4), alternately tightening SCREWS (3). Replace CAP (2) and HANDLE (1). Check flow.

POINTER ON

HOT LIMIT STOP

"B"

ADJUSTMENT WHEN WATER IS TOO COLD

"B"

PRY RED RING FORWARD AND ROTATE CLOCKWISE

ADJUSTMENT WHEN	"A"
WATER IS TOO HOT

PRY RED RING FORWARD

AND ROTATE COUNTER-

CLOCKWISE ONE CLICK

0

1

2

3

4

5 6

5

RED RING HOT

LIMIT SAFETY

STOP

	1
3	2
4

12 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

M968760 Rev . 1 . 3

4