American Standard 2096.333 dimensions High Hamiltonelongated SPACE-SAVING ONE-PIECE Toilet

HIGH HAMILTON™ELONGATED

SPACE-SAVING ONE-PIECE TOILET

BARRIER FREE VITREOUS CHINA

HIGH HAMILTON™ ELONGATED SPACE- SAVING ONE-PIECE TOILET

•Vitreous china

•Low-consumption (6.0 Lpf/1.6 gpf)

•One-piece toilet features a higher (427mm 16-13/16”) bowl for added comfort

•Elongated siphon action bowl and tank with unique space-saving feature

•Fits into the same space as a conventional round front toilet

•Color-matched trip lever

•Internal trapway area fully glazed

•Includes color-matched Rise and Shine™ plastic seat and cover (#5324.019) with easy-to-clean lift-off hinge system

•2 bolt caps

•100% factory flush tested

❏2096.016

❏2096.333

•Right-hand trip lever

Nominal Dimensions: 692 x 457 x 699mm

(27-1/4" x 18" x 27-1/2")

Fixture only, supply by others

Compliance Certifications -

Meets or Exceeds the Following Specifications:

•ASME A112.19.2M (and 19.6M) for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

To Be Specified

❏Color:

❏Supply with stop:

MEETS THE AMERICAN DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USEABLE BUILDING FACILITIES-CHECK LOCAL CODES.

●When installed, top of seat meets minimum requirement of 432 to 483mm (17" to 19") from the finished floor.

FINISHED WALL
	692mm
	(27-1/4)
184mm
(7-1/4)
	C/L OF SEAT		457mm
13mm	POST HOLES		(18)
(1/2)	140mm (5-1/2)
	CENTERS
	481mm
	(18-15/16)
			C/L
	427mm
	(16-13/16)		699mm
		SUPPLY AS	(27-1/2)
		REQUIRED
		FINISHED
76mm		FLOOR
(3)
	16mm	*152mm	*152mm
	(5/8)
		(6)
164mm	243mm		(6)
(6-7/16)
	(9-9/16)		229mm
			(9)
305mm			368mm
(12)			(14-1/2)

NOTE: Roughing-in information shown on reverse side of page

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.

*DIMENSIONS SHOWN FOR LOCATION OF SUPPLY ARE SUGGESTED. SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerance established by ANSI Standard A112.19.2.

These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

	10
© 2004 American Standard Inc.	Revised 10/04