2 DRAIN INSTALLATION
1 | Remove Lift and Turn Stopper and Tailpiece Assembly from box and check that all |
| parts are included. Remove Lift and Turn Stopper Assembly from Tailpiece by setting |
| Stopper to closed position, and turning Stopper Knob |
| |
2 | Apply plumbers putty around drain hole and pipe thread compound on threaded |
| end of tailpiece. |
3 | Set Tailpiece in drain hole. (Lift and Turn Stopper Assembly should be removed, |
| and reinstalled after tub installation is completed.) |
4 | From underside of tub: Place Rubber Wedge Seal on Tailpiece, small end toward tub, |
3
INSTALLATION
Position bathtub within the recess, check level, front to back, side to side. Also check drain clearance hole in sub floor. To secure the tub to wood studs, use roofing nails immediately above the flange of the tub.
To secure the tub to steel studs, use drywall screws and flat washers. (See Step 4)
Caution: Take Extra Care When Driving Nails or Screws To Avoid Damaging The Tub. The tile or similar finished floor will be butted against the bottom of the tub apron also holding the tub in place.
NOTE: Warranty will be voided if the drain is installed after the tub has been set in place.
and center in hole, place Brass Washer on Tailpiece, and thread on Locking Nut, flange |
side first. Tighten Locking Nut to obtain a uniform seal between Wedge Seal |
and hole in tub. |
DO NOT OVERTIGHTEN! |
Final hook up to tub waste can be made using either internal threads in Tailpiece
1 | STOPPER | |
| KNOB | |
TURN TO | STOPPER | |
ASSEMBLY | ||
REMOVE | ||
| ||
| TAILPIECE | |
| RUBBER | |
| DRAIN SEAL | |
| BRASS DRAIN |
NAIL
OR
DRYWALL
SCREW
EVERY STUD
UNDERLAYMENT |
FINISHED TILE FLOOR |
SUB FLOOR |
| WASHER | |
STOPPER IN | BRASS | |
DRAIN NUT | ||
OPEN POSITION | ||
| ||
STOPPER IN |
| |
CLOSED POSITION |
| |
(UNSCREW STOPPER ONCE IN |
|
4
Below is shown typical cross sections of the tub rim
showing typical wall constructions.
| CLOSED POSITION TO REMOVE) |
| |
|
| LIFT AND TURN |
|
|
| STOPPER ASSEMBLY |
|
3 |
|
| 2 |
SET |
| APPLY PIPE JOINT | |
TAILPIECE |
| ||
COMPOUND TO |
| ||
|
|
| |
|
| THREADS |
|
|
| APPLY PLUMBERS | 2 |
|
| PUTTY |
|
STUD
SHIM
DRY WALL
TILE
ROOFING NAIL
SEALANT
TUB
STEEL
STUD
SHIM
DRY WALL
TILE
SEALANT
TUB
WASHER
4"
DRYWALL SCREW
ASSEMBLE AND | 4 |
TIGHTEN |
2 x 4 WOOD
STRINGER FULL LENGTH
WOOD STUDS
2 x 4 WOOD STRINGER FULL LENGTH