American Standard 2446 Instructions To Install Toilet Seat, exactly depict the flush valve

INSTRUCTIONS TO INSTALL TOILET SEAT

12a 12b 12c

Place seat on bowl. Be careful to

Insert bolts in hinges.

Attach the nut from below.

center hinge over holes in bowl.

12d

12e

12f

TOILET SEAT CARE AND CLEANING

When cleaning your toilet seat wash it

with mild, soapy water: rinse the seat

thoroughly with clear water: and dry

with a soft cloth.

Avoid detergents, disinfectants, or

cleaning products in aerosol cans.

NEVER use abrasive scouring powders

on your seat. Some bathroom

chemicals and cosmetics may damage

the seat's finish. After installation, check

Use a screwdriver to tighten bolt.

Close the hinge covers.

the tightness of the bolts from time to

time to ensure a tight fit.

13

NOTE: Pictures are representative and may not

TROUBLESHOOTING

exactly depict the flush valve.

IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK

SLOWLY, repeat Step 13.

IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF

NON-USE,it is a signal you are wasting water because:

LIFT ARM

• The end of the refill tube is inserted into overflow pipe, below

FIRST

water level in tank. Attach refill tube to overflow pipe using "S"

clip provided.

• The flush valve is leaking because it's worn, dirty or misaligned

with tank ball or flapper (replace with a new flapper).

IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL

IMPORTANT: Always

OF TANK WATER IS SLOW after valve has been in use for

• While holding a

• Replace TOP by engaging

some time, Fluidmaster Model 242 Replacement Seal may be

clear sand and rust

needed.

container over the

lugs and rotating 1/8 turn

from system.

• Make sure water supply

uncapped VALVE to

clockwise. MAKE

Go to our website at www.fluidmaster.com for more

prevent splashing, turn

CERTAIN TIP IS TURNED

solutions to toilet problems.

is off. Remove valve TOP

water supply on and off

TO THE LOCKED

by lifting arm and rotating

For troubleshooting information please contact:

a few times. Leave

POSITION. VALVE MAY

top and arm 1/8 turn

water supply off.

NOT TURN ON IF TOP IS

counterclockwise, pressing

down slightly on cap.

NOT FULLY TURNED TO

30800 Rancho Viejo Road

THE LOCKED POSITION.

San Juan Capistrano, CA 92675

GUARANTEE: This Fluidmaster product is guaranteed to be free from defective materials and

(949) 728-2000 (800) 631-2011

www.fluidmaster.com

workmanship for a period of one year. Units returned to Fluidmaster will be replaced without charge.

Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster shall not be responsible or liable for any damages caused by products used with Fluidmaster valves that were not manufactured by Fluidmaster, Inc.

© 2001 Fluidmaster, Inc.

® Registered trademark of Fluidmaster, Inc.

- 4 -

7301186-100 Rev. B